PFM T31 Transmitter
PRODUCT IS REPLACEMENT OF THE PRODUCT. NO PERSON HAS ANY AUTHORI-
TY TO BIND WILLIAMS SOUND TO ANY REPRESENTATION OR WARRANTY WITH
RESPECT TO THE PFM T31 TRANSMITTER. UNAUTHORIZED REPAIRS OR MODIFI-
CATIONS WILL VOID THE WARRANTY.
Instructions For Use & Care
Thank you for purchasing the PFM T31 transmitter from Williams Sound. The T31 trans-
mitter is designed to operate with a wide-band FM, 72–76 MHz receiver. For optimal per-
formance, we recommend using the Williams Sound R31 or R32 receiver. Please call a
Williams Sound representative for more information: 800-843-3544.
How it Works: The T31 transmitter uses a microphone (not included) to pick up the desired
sound source. The speaker talks into the microphone, and the T31 transmitter broadcasts the
message over an FM radio signal. Listeners wear FM receivers to pickup the broadcast and
hear the speaker’s message.
The exclusions and limitations set out above are not intended to, and should not be construed
so as to contravene mandatory provisions of applicable law. If any part or term of this
Disclaimer of Warranty is held to be illegal, unenforceable or in conflict with applicable law
by a court of competent jurisdiction, the validity of the remaining portions of this Disclaimer
of Warranty shall not be affected, and all rights and obligations shall be construed and
enforced as if this Limited Warranty did not contain the particular part or term held to be
invalid.
If you experience difficulty with your system, call Toll-Free for Customer Assistance:
1-800-843-3544
Components:
PFM T31 Body pack transmitter
On/Off Switch
BAT 001 AA Alkaline Batteries
If it is necessary to return the system for service, your Customer Service Representative will
give you a Return Authorization Number (RA) and shipping instructions.
Mic
Off
FM
On
Mic
Instructions:
Williams Sound FM
Pack the system carefully and send it to:
Before you begin, make sure you have AA
Alkaline batteries installed in the transmit-
ter. See Battery Information on page 2.
Williams Sound Corp.
Attn: Repair Dept.
Mic Jack
Mic Mute Switch
1. Plug the microphone into the “mic” jack
on top of the transmitter.
10321 West 70th Street
Eden Prairie, MN 55344
the switch to the “Off” position. This will
eliminate any unwanted noise as a result of
the transmitter being on.
2. Turn the power on: Place the FM switch
to the “On” position.
Note: The microphone cord is also the
transmitting antenna. For maximum range,
make sure the microphone cord is hanging
as straight as possible.
3. Position the microphone as close to the
speaker’s mouth as practical.
4. When you are ready to speak, turn the
Mic Mute Switch to the “On” position.
When you are done speaking, mute the mic
by turning
5. Remember to turn the transmitter off
when you are done using it: Turn the “FM”
switch to the “Off” position.
®
10321 West 70th St., Eden Prairie, MN 55344 U.S.A.
MAN 109C
©2005, Williams Sound Corp.
800.843.3544 | 952.943.2252 | FAX: 952.943.2174
®
MAN 109C ©2005, Williams Sound Corp.
|